Utilize
the following instructions to complete the wireless Mac setup for your HP Envy 4520 printer.
- Make sure
your printer, router and your computer are all switched onto begin the wireless
setup for Mac.
- Along
with its password,make a note of the name of your network.
- It is
very important that you remove all other cables like the Ethernet and the USB
cables when you are doing a wireless setup.
- It is
mandatory to reset the wireless settings if you already tried connecting to some
other wireless network or the same network.
- When the
power indication light is bright you know that your printer is awake.
- Check the
wireless light and press and hold the wireless and the cancel buttons
simultaneously for 3 secs.
- With the
printer software and the necessary drivers,your printer now needs to be
installed.
- Open the HP Easy Start software and select the Set up my Printer option.
- Your
printer’s details will be listed on the connect
screen.
- Retry
connecting once again if you do not find your printer listed in this page then.
- Once you
are connected to it,you have the option of renaming your printer.
- Either
manually or automatically,enter your network’s password when there is a key chain
request prompt.
- To
complete the wireless setup for Mac, now you can follow the onscreen instructions
- Like the HP Essential Software and HP Easy Scan,there is additional
software that you can choose to install,
- You will
have to do the setup procedure once again,in case, you happen to change your
network’s password sometime in between.
- To make
sure that the printer has been setup and installed successfully, do a test
print on your printer.
- And also,
verify the ink levels in the cartridges.